| Weights |
|---|
| Empty Weight | 549998.2 lb
|
|---|
| Gross Weight | 1270021.3 lb
|
|---|
| Weight | 89999.4 lb
|
|---|
| Weight (Dry) | 24802.1 lb
|
|---|
| Weight (Wet) | 25904.4 lb
|
|---|
|
| Engine & Fuel System |
|---|
| Engine Make | 2238
|
|---|
| Engine Model | SSDA18V170
|
|---|
| Fuel Tank | 1400.2 gal
|
|---|
| Fuel Type | diesel
|
|---|
| Horse Power: Sae J1995 | 3500.1 hp
|
|---|
| Number Of Cylinders | 18
|
|---|
| Power Measured @ | 1900 rpm
|
|---|
| Cooling System | 190 gal
|
|---|
| Displacement | 4759.9 cu in
|
|---|
|
| Drive System |
|---|
| Emergency Brakes | Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements.
|
|---|
| Parking Brake Type | Multiple disc, spring-applied, hydraulically-released, dry brakes on inboard end of each wheel motor rotor shaft. Rated to hold on ±15% grade at maximum gross vehicle weight.
|
|---|
| Service Brake Type | Oil-cooled, hydraulic-actuated, multiple disc brakes at each wheel.
|
|---|
| Wheel Brake Locks | Switch-activated
|
|---|
| Hoist And Steering | Dual, in-line, high pressure
|
|---|
|
| Operating Specs |
|---|
|
|
| Hydraulic System |
|---|
| Hydraulic System | 350.1 gal
|
|---|
| Pumps | Two pumps, single package, end of alternator
|
|---|
| Filtration | In-line replaceable elements
|
|---|
|
| Dimensions, Wheels & Tires |
|---|
| Standard Tire | 53/80 R63
|
|---|
| Wheelbase | 21.76 ft in
|
|---|
| Width Over Tires-Rear | 28.68 ft in
|
|---|
| Turning Radius | 52.5 ft in
|
|---|
| Overall Length | 503.29 ft in
|
|---|
| Overall Height | 25.17 ft in
|
|---|
| Front | 328
|
|---|
| Rear | 239
|
|---|
|
| Battery & Electrical System |
|---|
| Alternator | 24 volt, 250 amp
|
|---|
|
| Transmission |
|---|
| Motor Gear Box | 37 gal
|
|---|
| Maximum Speed (Km/H) | 64.5
|
|---|
|
| Technical Specs |
|---|
| Ratio | 38:12 :1
|
|---|
| Control | AC Torque Control System
|
|---|
| Drive System | Komatsu AC Drive
|
|---|
| Dual Fan Main Blower | Alternator Flow- 266 m3/min 9,380 cfm Wheel Motor Flow- 419 m3/min 14,800 cfm
|
|---|
| Lighting | 24 volt
|
|---|
| Cranking Motors | Two/24 volt
|
|---|
| Capacity - Struck | 194.9 yd3
|
|---|
| Heaped (2:1, Sae) | 280 yd3
|
|---|
| Payload | 719996.7 lb
|
|---|
| Structure | Flat floor configuration
|
|---|
| Canopy Sheet | 06 mm 0.24' 690 Mpa 1,00,000 psi tensile strength steel
|
|---|
| Front Sheet | 10 mm 0.39' Outer, 12 mm 0.47' Center, 1379 mPa 200,000 psi tensile strength steel
|
|---|
| Side Sheet | 10 mm 0.39' 1379 Mpa 2,00,000 psi tensile strength steel
|
|---|
| Floor Sheet | 16 mm 0.63' Outer, 19 mm 0.75' Center, 1379 mPa 200,000 psi tensile strength steel
|
|---|
| Loading Height | 23.5 ft in
|
|---|
| Crankcase | 90.1 gal
|
|---|
| Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping.
|
|---|
| Relief Pressure | Hoist and brake cooling- 17237 kPa 2,500 psi Steering and brake-20685 kPa 3,000 psi
|
|---|
| Hoist Time | Power-up loaded: 24 sec, Power-down: 14 sec, Float-down empty:24 sec
|
|---|
| Turning Circle Diameter (Sae) | 105 ft in
|
|---|
| Reservoir | 250 gal
|
|---|
| Suction | Single, full flow, 100 mesh
|
|---|
|
