Weights |
Empty Weight | 474670.7 lb
| Gross Weight | 1114998.9 lb
| Weight | 22266.7 lb
|
---|
|
Engine & Fuel System |
Engine Make | 2238
| Engine Model | SSDA18V170
| Fuel Tank | 1400.2 gal
| Fuel Type | diesel
| Horse Power: Sae J1995 | 3501.5 hp
| Number Of Cylinders | 18
| Power Measured @ | 1900 rpm
| Cooling System | 190 gal
| Displacement | 4759.9 cu in
|
---|
|
Drive System |
Emergency Brakes | Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements.
| Parking Brake Type | Multiple disc, spring-applied, hydraulically-released, dry brakes on inboard end of each wheel motor rotor shaft. Rated to hold on ±15% grade at maximum gross vehicle weight.
| Service Brake Type | Oil-cooled, hydraulic-actuated, multiple disc brakes at each wheel.
| Wheel Brake Locks | Switch-activated
| Hoist And Steering | Dual, in-line, high pressure
|
---|
|
Operating Specs |
|
Hydraulic System |
Hydraulic System | 350.1 gal
| Pumps | Two pumps, single package, end of alternator
| Filtration | In-line replaceable elements
|
---|
|
Dimensions, Wheels & Tires |
Standard Tire | 53/80 R63
| Wheelbase | 20.84 ft in
| Width Over Tires-Front | 24.68 ft in
| Width Over Tires-Rear | 27.33 ft in
| Motorised Wheels | GDY106 Induction Traction Motors
| Turning Radius | 49.87 ft in
| Overall Length | 51.19 ft in
| Overall Height | 24.18 ft in
|
---|
|
Battery & Electrical System |
Alternator | 24 volt, 140 amp
|
---|
|
Transmission |
Motor Gear Box | 25.1 gal
| Maximum Speed (Km/H) | 64.5
|
---|
|
Technical Specs |
Ratio | 32.62:1
| Control | AC Torque Control System
| Lighting | 24 volt
| Cranking Motors | Two/24 volt
| Capacity - Struck | 223.7 yd3
| Heaped (2:1, Sae) | 276 yd3
| Payload | 640328.2 lb
| Structure | Flat floor configuration
| Canopy Sheet | 5 mm 0.19'' 690 mPa 100,000 psi tensile strength steel
| Front Sheet | 9 mm 0.35'' 1379 mPa 200,000 psi tensile strength steel
| Side Sheet | 8 mm 0.31'' 1379 mPa 200,000 psi tensile strength stee
| Floor Sheet | 16 mm 0.63'' 1379 mPa 200,000 psi tensile strength steel (two-piece)
| Loading Height | 23.2 ft in
| Crankcase | 90.1 gal
| Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping.
| Relief Pressure | Hoist and brake cooling- 17237 kPa 2,500 psi Steering and brake-25759 kPa 4,000 psi
| Hoist Time | Power-up loaded: 21 sec, Power-down: 23 sec, Float-down empty:24 sec
| Turning Circle Diameter (Sae) | 97.7 ft in
| Reservoir | 250 gal
| Suction | Single, full flow, 100 mesh
|
---|
|