Weights |
Empty Weight | 441698.4 lb
| Gross Weight | 1001698.9 lb
| Weight | 21182.1 lb
|
---|
|
Engine & Fuel System |
Engine Make | 2238
| Engine Model | SSDA16 V160
| Fuel Tank | 1199.9 gal
| Fuel Type | diesel
| Horse Power: Sae J1995 | 2700.9 hp
| Number Of Cylinders | 16
| Power Measured @ | 1900 rpm
| Cooling System | 125 gal
| Inverter Cooling System | 6.7 gal
| Displacement | 3661.5 cu in
|
---|
|
Drive System |
Emergency Brakes | Automatically applied prior to hydraulic system pressure dropping below level required to meet secondary stopping requirements.
| Parking Brake Type | Multiple disc, spring-applied, hydraulically-released, integral wet disc park brake Rated to hold on ±15% grade at maximum gross vehicle weight.
| Service Brake Type | Oil-cooled, hydraulic-actuated, multiple disc brakes at each wheel.
| Wheel Brake Locks | Switch-activated
| Hoist And Steering | Dual, in-line, high pressure
|
---|
|
Operating Specs |
|
Hydraulic System |
Hydraulic System | 350.1 gal
| Reserve Oil System | 30.2 gal
| Pumps | Two pumps, single package, end of alternator
| Filtration | In-line replaceable elements
|
---|
|
Dimensions, Wheels & Tires |
Standard Tire | 50/80 R57
| Wheelbase | 20.84 ft in
| Width Over Tires-Rear | 26.19 ft in
| Turning Radius | 50.86 ft in
| Overall Length | 48.99 ft in
| Overall Height | 23.96 ft in
|
---|
|
Battery & Electrical System |
Alternator | 24 volt, 140 amp
| Electric Dynamic Retarder (Max.) | 3469kW Continuously rated high-density blown grids w/retard at engine idle and reverse propulsion.
|
---|
|
Transmission |
Motor Gear Box | 32 gal
| Maximum Speed (Km/H) | 64.5
|
---|
|
Technical Specs |
Ratio | 35.52:1
| Control | AC Torque Control System
| Drive System | Komatsu AC Drive
| Dual Fan Main Blower | 419 m3/min 14,800 cfm
| Lighting | 24 volt
| Cranking Motors | Two/24 volt
| Capacity - Struck | 159.6 yd3
| Heaped (2:1, Sae) | 221.1 yd3
| Payload | 560774.4 lb
| Structure | Flat floor configuration
| Canopy Sheet | 6 mm 0.24'' 690 MPa 100,000 psi tensile strength steel
| Front Sheet | 10 mm 0.39'' Outer 10 mm 0.39'' Center 1379 MPa 200,000 psi tensile strength steel
| Side Sheet | 8 mm 0.31'' 1379 MPa 200,000 psi tensile strength steel
| Floor Sheet | 16 mm 0.63'' Outer 19 mm 0.75'' Center 1379 MPa 200,000 psi tensile strength steel
| Loading Height | 20.9 ft in
| Crankcase | 74 gal
| Hoist Cylinder | Two 3-stage dual-acting outbound cylinders and internal cushion valve, over-centre damping.
| Relief Pressure | Hoist and brake cooling- 17237 kPa 2,500 psi Steering and brake-20685 kPa 3,000 psi
| Hoist Time | Power-up loaded: 22 sec, Power-down: 13 sec, Float-down empty:23 sec
| Turning Circle Diameter (Sae) | 101.8 ft in
| Reservoir | 250 gal
| Suction | Single, full flow, 100 mesh
|
---|
|